back to top
My wish lists
Save your wish list
If you want to add more content to your wish list, simply log in. If you do not have a user account, please register for the Hanser Customer Center.

» Do you already have a user account? Please log in here.
» Don't have a user account yet? Please register here.
Your wish lists
If you want to use your wish list during your next visit, simply log in. If you do not have a user account, please register for the Hanser Customer Center.
» Do you already have a user account? Please log in here.
» Don't have a user account yet? Please register here.

« Back

Your advantages at a glance

  • One login for all Hanser portals
  • Individual home page for faster access to preferred content
  • Exclusive access to selected content
  • Personal wish lists on all portals
  • Central management of your personal information and newsletter subscriptions

Register now
Deutsch
Bookmark Bookmarked
03-11-2015

Recovery of the European Injection Molding Industry

In a new report recently published by AMI Consulting the recovery of Europe's injection molding sector since the global recession has been examined in detail. The market research consultancy has calculated that the value of the European plastics injection molding industry in 2014 was 11% higher than its pre-crisis value: although the volume of polymer processed was still about 7% lower than in 2007. Much of the value increase is associated with higher raw material costs but the industry has striven to maximize the potential of new and added value opportunities.

The packaging sector remains by far the largest injection molding market in terms of polymer volume consumed, particularly because it includes demand for PET preforms. The packaging sector is almost equally important across every country because it typically serves local consumer demand. By comparison the automotive market is the most valuable injection molding sector and its demand is increasingly being focussed in countries retaining or attracting vehicle assembly. Within Europe the shift of molded volume from Western to Central and Eastern Europe has largely been a result of following the investment by customers, particularly the automotive and electrical appliance manufacturers. However, the economic development of these regions has also created a larger consumer market to the benefit of the whole molding sector.

The global recession accelerated the process of rationalisation of the European injection molding industry that had been underway for several years, particularly in Western Europe. Using analysis of AMI's proprietary injection molding database the report tracks the structural changes within the industry which is reported to involve more than 8,500 different companies across Europe. These range from small, family owned concerns up to multinational groups. The importance of molding to the overall business can also vary significantly hence a wide range of business models exist in the industry.

Injection molding demand by country in 2014 (figure: AMI)

Western Europe has continued to experience most contraction with more than 2,000 molding sites closing since 2007. In Central and Eastern Europe closures have been more than offset by new entrants: the region continues to attract a high level of new investment. The overall rate of decline in molding sites is forecast to slow down but, through extrapolation from its database, AMI forecasts that Europe will lose a further 2% of its injection molding sites by 2018. However, polymer demand and industry value for injection molded products is forecast to grow across almost every market sector. The higher demand will therefore be met by a smaller, yet more cost effective, strategically located supplier base.

contact

AMI

Newsletter

Would you like to subscribe to our Newsletters on plastics technology and profit from the latest information?

Subscribe here

Subscribe here

Job Advertisements

Looking for a new challenge? Check out our jobs market!

Job Advertisements

Patents Stimulate Innovation

Patents encourage innovation: Stay on the ball with the latest innovations in the plastics industry in our patents section.

Patents