Laser Sintering: Refreshing Strategies for Polyamide-12 Powder
Laser Sintering is increasingly emerging as an additive manufacturing method for low-volume production. If it is to make the breakthrough to mass production, however, a way must be found of upcycling the excess polymer powder to obtain the highest-possible quality. This can be done by using melt volume-flow rate instruments to determine the quality of the material and devising a suitable refreshing strategy.
Beitrag auf Deutsch lesen
1 Wohlers, T.: Wohlers Report 2013 - Additive Manufacturing and 3D Printing State of the Industry. Wohlers Associates Inc., Fort Collins, Colorado, 2013.
2 Hague, R.; Campbell, I.; Dickens, P.: Implications on Design of Rapid Manufacturing, In: Proceedings of the Institution of Mechanical Engineers, Part C. Journal of Mechanical Engineering Science, Vol. 217 (2003) No. 1, pp. 25–30.
3 Gebhardt, A.: Generative Fertigungsverfahren - Rapid Prototyping - Rapid Tooling - Rapid Manufacturing, 1, 3rd Edition. Carl Hanser Verlag, Munich 2007.
4 Dotchev, K.; Yusoff, W.: Recycling of Polyamide 12 based Powders in the Laser Sintering Process. Rapid Prototyping Journal, Vol. 15 (2009) No. 3, pp. 192–203.
5 Wegner, A.; Mielicki, C.; Grimm, T.; Gronhoff, B., et al.: Determination of Robust Material Qualities and Processing Conditions for Laser Sintering of Polyamide 12. Polymer Engineering and Science, (2013) No., DOI: 10.1002/pen. 23696
-
10-12-2018 Three at One Blow -
09-20-2017 Numbers that Count -
04-25-2019 Natural Fine-Tuning
International Polymer Processing, the journal of the Polymer Processing Society, is a discussion forum for the world-wide community of engineers and scientists in the field of polymer processing.
The journal covers research and industrial application in the very specific areas of designing polymer products, processes, processing machinery and equipment.
International Polymer Processing
If there are any questions concerning your subscription or online access, please contact:
abo-service@hanser.de