In-mould Lamination of Fabric with Controlled Needle Shut-off Systems: No Creasing with a Balanced System
Fabric-covered parts in vehicle interiors are increasingly being produced by in-mould lamination. The hot-runner systems required for this must meet special requirements. A model solution is offered by the compact systems from Incoe International, Rödermark/Germany.Beitrag auf Deutsch lesen
International Polymer Processing, the journal of the Polymer Processing Society, is a discussion forum for the world-wide community of engineers and scientists in the field of polymer processing.
The journal covers research and industrial application in the very specific areas of designing polymer products, processes, processing machinery and equipment.
If there are any questions concerning your subscription or online access, please contact: